Guardian Panel Mounts^TM

Utilized in a number of different scenarios, Guardian Panel Mounts can be used as a recessed low-voltage mounting ring, an adaptor for a NEMA-style surface mount box or a flush-mounted electrical box.

When used as a recessed low-voltage ring, a Guardian Panel Mount can be easily installed directly in the wall or any other structure, even a lectern, using mounting screws, fasteners or toggle bolts. Then a custom connector panel can be easily attached for added protection. As an adaptor for an electrical box, the panel mount can be ordered in the exact box size for surface mount installations or ordered one inch larger than the electrical box for flush-mounted applications where the extra wide flange covers any seam between the box and the surrounding wall. Guardian Panel Mounts are available in most standard NEMA electrical box sizes for both surface mount and flush mounting with standard depths of either one or two inches. Custom sizes and configurations are available upon request.

Guardian Panel Mounts are manufactured in heavy gauge steel with welded and ground corners and painted with a light textured finish. Eight pre-drilled holes on the outer flange enable easy mounting while eight tapped holes in the inner flange facilitate mounting the connector panel.

Wireworks Perfect Custom Panels and LumaVue Plates & Panels can be easily ordered specifically for use with Guardian Panel Mounts. Custom panels can be delivered ready to install by field personnel. Ordering is simple: just specify your next panel job with Guardian Panel Mounts and we’ll take it from there.

Guardian Panel Mounts can be ordered in virtually any size required and can be specified in custom paint finishes to comply with architectural requirements.